Huawei AP4050DN Hardware Installation And Maintenance Manual page 19

AP4050DN-HD
Hardware Installation and Maintenance Guide
3.
4.
5.
6.
7.
Issue 01 (2016-04-15)
Place the base bracket against the wall and use a wrench to fasten two expansion screws
into the expansion tubes.
Remove the topmost screw from the base bracket, hang the AP-side mounting bracket
onto the topmost screw, and tighten the screw until the screw passes through the hole of
the horizontal scale plate.
Connect the cables. For details, see 2.6 Cable Connection.
Align the mounting screws at the rear of the AP with the mounting holes on the bracket
and hang the AP on the bracket. Push the AP downward to secure the AP.
Loosen the two screws at the horizontal direction, adjust the AP's angle at the horizontal
and vertical directions, and tighten the hex socket screws. Use M4x35 cruciform slot
screws to tighten the AP and mounting bracket from the side.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
13