Epson Disc Producer PP-100NII User Manual page 174

Error Message
Disc pickup
error (ST1/2)
Disc release
error
Discs ejected
from ST2?
Drive tray
open/close error
Fan control
error
Ink cartridge
cover open
Ink problem
(C,LC,LM,M,Y,K)
Remedy
The arm cannot pick up the disc in the stacker.
If the indicated stacker is an input stacker, fully separate
and reload the discs in the stacker.
The arm cannot release the disc.
Do not remove the disc by hand. This could damage the
arm. Turn off the power of the product, and then turn it on
again. During the initialization operation of the product,
the arm releases the disc. If the same error message still
appears, repair is required. Please contact Customer Support.
Perform the procedure below.
1. Remove the published discs from Stacker 2.
2. Refill the discs if necessary.
3. Press the button.
Note: In Batch Mode, if Stacker 2 is removed during publishing
progress, it is always recognized as the input stacker when
loaded again.
-When the drive tray does not come out-
Turn off the power, and then turn it on again. If the drive
trays still does not come out, see "Drive tray does not come
out" in PP-100NII Administrator's Guide. If the same error
message appears again, repair is required. Please contact Epson
Information Center.
-When the drive tray does not close-
Remove any remaining discs, turn off the power, and then
turn on the power again. If the same error message still
appears, repair is required. Please contact Epson Information
Center.
Turn off the power, and then turn it on again. If the same
error message still appears, repair is required. Please contact
Customer Support.
Close the ink cartridge cover.
This product is currently operating.
Close the ink cartridge cover.
An invalid ink cartridge is installed.
Replace the cartridge of the displayed color. (See "Changing
the ink cartridge" on page 151 in this guide.)
Troubleshooting
Notification
Sound
174