Preparation; Installing The Software; Before Installation - Epson Disc Producer PP-100NII User Manual

Preparation

Installing the software

This section describes the installation procedure of the software required for using this product (PP-100NII). After
setup of this product (see the PP-100NII Administrator's Guide) is completed, use the procedure below to install the
software onto the user's client computer.

Before installation

This installation procedure installs the following software. (It is also possible to install the printer driver only.)
• Printer driver
• EPSON Total Disc Setup
This software is used to register this product.
• EPSON Total Disc Monitor
This software is used to verify the product status from the client computer.
• EPSON Total Disc Maker
This software is used to edit the write data and the print data for the label surface and to publish using this
product.
• Important Note
You may use the Software to operate the EPSON products. You may use the EPSON
products to copy materials on to media, including but not limited to CDs, DVDs, and BDs.
You agree to respect the rights of copyright owners. EPSON shall have no liability for, and
you shall hold EPSON harmless from, any copyright infringement by you or your
employees, representatives or agents.
• Be sure to install the software by following the procedure in this guide.
• When installing the software, log on as a user with administrator privileges (belonging to
the administrator group). The software cannot be installed if you log on with user
privileges.
• When EPSON Total Disc Maker is installed, several Windows components may be installed.
Some of the installed components may not be uninstalled (deleted) when EPSON Total Disc
Maker is uninstalled.
• If the system and user language settings are different, the installation procedure may not
be performed properly. Install in an environment where the system and user languages are
the same.
Preparation
24