Epson Disc Producer PP-100NII User Manual page 8

Install this product in the following type of place.
Place that is flat and stable
• When using this product in a place where static electricity is easily generated, use an
antistatic mat or other product to prevent static electricity.
• Do not install on a surface that is smaller than the base of the product.
If the rubber bases on the bottom of the product extend beyond this surface, it places stress on
the internal mechanisms, which negatively affects disc writing, printing and transporting. Be
sure to install on a flat surface that is wider than the product so that all of the feet on the base of
the product rest firmly on it.
Do not block the air vents on this product.
Blocking the air vents may result in internal heat build-up and fire.
WARNING Do not install in the following types of places.
• Tight spaces where ventilation is poor, such as in a closet or on a bookshelf
• On a rug or bed
If you place the product by a wall, leave more than 10 cm between the back of the
product and the wall. It is also necessary to leave enough space in front of the
product to open and close the disc cover.
Do not install in a place where volatile substances, such as alcohol or paint
thinner, are present or in a place where there is fire.
This may result in electric shock or fire.
Do not install or store in an unstable place (such as on a wobbly or tilted
surface), in reach of children, or in a place subject to vibration from other
CAUTION machines.
There is a risk that it could drop or fall over, resulting in injury.
Do not install in places where there is excessive moisture or dust, risk of
getting wet, direct sunlight, severe changes in temperature and humidity, or
close to heating and cooling devices.
There is a risk of electric shock, fire, and malfunction or failure of this product.
Place with the following temperature and
humidity range
Before Using This Product
8