Table of Contents
Advertisement
Cautions for Use
1)
Do not connect the system to a power supply outside the rated voltage/frequency range listed on
the system or in this manual. Doing so could cause it to become damaged.
2)
Please use the system within the ambient conditions listed below. Using under other than the
indicated conditions could shorten the system lifetime.
* Ambient temp.:
* Relative humidity:
* Environment for use:
* Ambient storage temp.:
3) Do not place items on top of the main unit, or block the air vents around the system. Excessive heat
could damage the unit due to overheating.
4) When handling the LED head, do not touch the lens or LED with your bare hands.
If foreign matter adheres to the lens or LED, the UV intensity could drop, decreasing the curing
capacity. If touched with a bare hand or becomes soiled, wipe clean with alcohol.
5) Do not drop the LED head, or subject it to strong jolts. Doing so could damage the product.
6) Do not bend the connecting cable to the LED head multiple times. Doing so could cause a break in
the cable.
If the cable to the LED head is broken, the entire unit must be replaced.
7) Make sure the system's rubber legs are set horizontally parallel before use.
Using the system while it is titled, tipped on one side, or upside down could cause the system to
overheat and break. Doing so is also dangerous.
8) Noise superimposed over the power supply could cause the LED head or control power to
malfunction. In such a case, install an insulating transformer or noise filter.
9) Do not use the same power supply as motors, conductive machinery, or apparatuses that consume
large amounts of power.
10) Always use the supplied cables to connect the LED head and main unit.
11) The system is equipped with a power thermistor to suppress inrush current. Wait at least 5 times
between turning the power on or off.
* Any failures that occur within 1 year of delivery, under conditions of normal use, will be repaired free
of charge.
Note, however, that failures due to your fault, consumables and inevitable failures shall be
excluded.
* The warranty for the LED head is valid for 1 year from delivery or 5,000 hours of cumulative
irradiation, whichever comes first.
・ We cannot compensate losses due to halted production or defects caused by system issues.
vi
Main unit: 10 to 40
o
o
Head: 5
C to 35
No greater than 85%, with no condensation
Low levels of dust, debris, and oil mist. No extreme temperature
changes, or severe jolts or vibrations.
o
o
-10
C to 60
C; Relative humidity: No greater than 85% (no
condensation)
Warranty
Compensation for Production
o
C
C
Advertisement
Table of Contents
