Hitachi PC-ARFG-E Installation & Operation Manual page 65

SERVICE & INSTALLATION MENU
Element Optional function
Calibration of remote
Jc
controller sensor
K1 Not used
K2 Not used
K3 Not used
K4 Not used
Detection level of the motion
K5
sensor kit
Selection of allowed
operation modes when the
K6
control sensor of the indoor
unit is set by C8 function
Radiation Temperature
K7
Sensor Calibration
K8 Not used
51 PMML0565 rev.1 - 04/2022
Individual
Settings
setting
00
01
02
03
04
05
06
07
X
08
09
10
11
12
13
14
15
00
-
01
00
-
01
00
-
01
00
01
-
02
03
00 Standard (factory setting)
01 High
O
02 Low
00 All modes allowed
01 Only cooling/dry allowed
O
02 Only heating allowed
03 All modes allowed
00 Normal
01 Upper
O
02 Lower
03 Normal
00
- -
01
Setting conditions
-0°C
-0.5°C
-1.0°C
-1.5°C
-2.0°C
-2.5°C
-3.0°C
-3.5°C
+0.5°C
+1.0°C
+1.5°C
+2.0°C
+2.5°C
+3.0°C
+3.5°C
-0°C
-
-
-
-
Description
Offset for the remote controller
sensor
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Models:
RPF(I)-FSN2E
Not available, use at 00
conditions.
This parameter defines the
sensitiveness of the motion
sensor. The amount of activity in
the room is assessed according
to a different scale based on this
setting.
Detailed information about the
operation of the motion sensor
can be found in the technical
documentation of the indoor
units.
This function is used to select
the operation modes in which
the setting of C8 (use of remote
control switch sensor or remote
sensor on THM4 to control the
indoor unit) is enabled.
Only available for units with
radiant sensor
Use at 00 conditions