Comfort Setting; Gentlecool; Louver Direction In Cooling/Heating Mode - Hitachi PC-ARFG-E Installation & Operation Manual

FUNCTION MENU

5.8 COMFORT SETTING

1 In order to access the Comfort settings menu, select
"Comfort Setting" on the "Function Menu" screen and press
"OK".

5.8.1 GentleCool

This function, is used to control discharge air temperature when
system is operating in the cooling mode.
1 Once in the Comfort setting menu, press " " or " " to select
"GentleCool Comfort", and then press "OK".
2 Press " " or " ", the selected comfort level changes as
follows:
"Not Set" ↔ "LOW" ↔ "MED" ↔ "HIGH".
Select the GentleCool Comfort Level during cooling and
press "OK".
Press one " " to return to the "Comfort Setting" screen.
21 PMML0565 rev.1 - 04/2022
?
N O T E
• This function cannot be set when the indoor unit does not support
this function.
• According to the selected setting between LOW/MED/HIGH, the
system will apply a determined air outlet target temperature value in
order to prevent air flow from being too cold.
LOW: 12°C / MED: 14°C / HIGH: 16°C
• The effect may not be sufficient if two or more units are operating in
the room, which the air may be "cold".
• When this function is set, it may take time for the entire room to cool
down.

5.8.2 Louver direction in cooling/heating mode

Louver direction setting (in cooling mode or in heating mode), that
is available only for the latest RCI-FSR using the motion sensor
installed in the panel P-AP160NAE2, is used to control the air
flow of the room. Setting procedure is the same for both modes.
This function is available only for the RCI-FSR indoor units
(4 way cassette units), equipped with the motion and radiation
sensor installed in the panel P-AP160NAE2. According to the
setting chosen by the user (indirect or direct air), the indoor unit
will adapt the operation of the air louvers to avoid blowing air
directly on the users or it will target directly the users for a fresh
air effect.
1 Once in the Comfort setting menu, press " " or " " to select
"Louver Direction in Cooling Mode", and then press "OK".
2 Press " " or " ", the louver direction setting changes as
follows:
"Normal" ↔ "Indirect air" ↔ "Direct air"
Select the desired setting and press "OK".
Press once " " to return to the "Comfort Setting" screen.