Advertisement
Operation and application
5.3 Display status of keypad
Displaying status include the stopped state parameter display, the running status
parameter display, the function code edition display and the fault warning condition
display etc.
1. The stop status parameter display
The drive is at stop state. The LED displays the stop state parameters. You can press
">>" to by turns display different parameters at stop state. (User can set which
parameters are to be displayed at stop state in FE group function codes.)
2. The running state parameter display
The drive is running and the LED displays the running state parameters. You can
press "»" to display by turns the different running state parameters. (User can set
which parameters are to be displayed at running state in FE group function codes.)
3. Fault and warning state
If the drive has detected a warning signal, it comes into warning state and blinks the
warning code. If the warning signal disappeared, the warning code will automatically
disappear.
If the drive has detected an error, it comes into fault state and show the fault code
steadily. And the indicator TRIP will light on. By pressing the ">>"key, user can view
the parameters value of stop state. If you want to see the details of fault information,
press the "PRG" key to enter programming state and check parameter group FF.
User can reset the drive by STOP key, terminal or communication. If the fault signal
still exists, the keypad keeps displaying the fault code.
4. Function code setting state
No matter it is under stop state, running state or warning/fault state, it is valid to
press PRG key to enter parameter setting. The detailed setting method is instructed
in this manual section-4.2.
5.4 Password Setting
The drive provides user password setting function. When FP.00 is set to non-zero
value, which is the user password, the password protection turns valid after exiting
the editing status. When the user goes to FP group again and presses ENTER, it
shows "0000". Correct password should be input to unlock the protection status to
enter FP group again. To disable this password protection, user need to input the
correct password first and then change FP.00=0.
SINAMICS V50 converter
22
Operating Instructions, 04/2022, FW V1.0, A5E44777205B AB
Advertisement
