Interfaces; Interface Selection; Configuring The Interface - HP Linear Barcode Scanner II Programming Reference Manual

Interface Selection

Each reader model will support one of the following sets of host interfaces:
USB KBD
USB COM STD
USB OEM
USB Composite

Configuring the Interface

Scan the programming bar code from this section which selects the appropriate
interface type matching the system the reader will be connected to. Next, pro-
ceed to the corresponding chapter in this manual (also listed in
figure any desired settings and features associated with that interface.
NOTE
Programming Reference Guide
Unlike some other programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT scan an
ENTER/EXIT bar code prior to scanning an interface selection bar code.
Some interfaces require the reader to start in the disabled state when powered
up. If additional reader configuration is desired while in this state, pull the
trigger and hold it for five seconds. The reader will change to a state that
allows programming with bar codes.
Chapter 3

Interfaces

Table 1) to con-
7