HP Linear Barcode Scanner II Programming Reference Manual page 257

Label ID: Set Individually Per Symbology — continued
Table 14. Label ID Examples
STEP ACTION
Scan the ENTER/EXIT bar
1.
code
Determine placement of the
Label ID characters BEFORE
or AFTER with regard to
2.
scanned data using "Label ID
Control" on page 39
Scan the bar code selecting the
symbology type you wish to
designate label ID characters
3.
for using Label ID Symbology
Selection, starting on page
40 .
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
ASCII table (inside back
cover), then scan in these digits/
characters using the bar codes
in the section:
Keypad, starting on page
5.
281 . f you make a mistake
before the last character, scan
the CANCEL bar code to abort
and not save the entry string.
You can then start again at the
beginning.
Scan theENTER/EXIT bar
6.
code
Scan the ENTER/EXIT bar
7.
code once again
Result:
Programming Reference Guide
EXAMPLES
(Reader enters Programming Mode)
Enable as Prefix Enable as Suffix
GS1 DataBar
Code 39
Omnidirectional
D B * = C 3
44 42 2A 3D 43 33
(Reader exits Label ID entry)
(Reader exits Programming Mode)
DB*[bar code [bar code
data] data]=C3
Enable as Prefix Enable as Suffix
Interleaved 2 of 5 Code 32
+
2B 50 48
+[bar code data] [bar code data]PH
Data Editing
P H
247