Table of Contents
Advertisement
Set Length 2
This feature specifies one of the bar code lengths for a given symbology.
Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. Length includes the bar code's data char-
acters only.
Reference the
ber of characters) for the symbology being set.. A setting of 00 specifies to
ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode.
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
represent the length setting which was determined in the steps above. You
will hear a two-beep indication after the last character.
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See
this feature.
Table 21. Length 2 Setting Examples
STEP
ACTION
1
Desired Setting
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5
Scan ENTER/EXIT PROGRAMMING MODE
258
Symbologies on page 65
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again at
the beginning.
EXAMPLES
00 (ignore second
07 Characters
length)
'0' and '0'
section to view the selectable range (num-
Appendix D,
Table 21
for some examples of how to set
52 Characters
'0' and '7'
'5' and '2'
Programming Reference Guide
Keypad, that
74 Characters
'7' and '4'
Advertisement
Table of Contents
