Table of Contents
Advertisement
Click on button „Auto" to auto erase FLASH, writing the program and
verifying.
Using Processor Expert
Successfully codesigned and compiled project from Processor Expert
environment can be directly burned into internal/external flash using
command from Tools menu. Target flash selection and path to ABS-file is
generated to configuration file according to the project settings.
H O W
T O
B U R N
The current version of the Softune Debug monitor is provided in two variants,
that differs in their communication speed: the first (
where xxx is the CPU type) communicates on 38400 Bd, the second
(
SoftuneMonitor9600_xxx.abi
When using the 38400 Bd variant, the Devkit16 UART must be configured for
RTS/CTS hardware flow control mode (J9 must be in the 2-3 position),
otherwise some data can be lost during the communication. To burn the Softune
debug monitor to the Devkit16 external FLASH, follow these steps:
1. From the PE environment:
For the 38400 variant:
From the Tools menu, choose the item „Burn Softune Monitor for
MB90xxx into Devkit16 Ext. FLASH (38400 Bd) ", where xxx
stands for the CPU type (e.g., 543 or 497).
For the 9600Bd variant:
From the Tools menu, choose the item „Burn Softune Monitor for
MB90xxx into Devkit16 Ext. FLASH (9600 Bd) ", where xxx
stands for the CPU type (e.g., 543 or 497)..
2. Without PE
Without PE, the monitor debugger must be burned using command line:
•
change the current directory to the Processor Expert installation
directory (for example, c:\Program Files\PE)
• run the following command:
flashtool -cfg Config\FlashTool\FujitsuDevKit16\SoftuneMonitor38400_xxx.ftc
for the 38400 Bd variant (where xxx is the CPU type) or
flashtool -cfg Config\FlashTool\FujitsuDevKit16\SoftuneMonitor9600_xxx.ftc
for the 9600 Bd variant (where xxx is the CPU type).
T H E
S O F T U N E
, where xxx is the CPU type) uses only 9600 Bd.
32
32
32
32
D E B U G
M O N I T O R
SoftuneMonitor38400_xxx.abi
,
Advertisement
Table of Contents
