Table of Contents
Advertisement
these facts.
• An error was found in the chapter "Mainboard
description" – the Prototype connector had
different pinout than the one in the schematics
(the schematics are correct, however)
04.03.2000
An error in the FLASH end address in the SWAP
mode - on the page 73, FLASH ends at 140000H
(not 180000H)
• In the chapter 4, paragraph "Get it running", the
11.05.2000
Softune Workbench is recommended to be run
first (with the "Demo.LEDs" project). However,
the Softune *.PRJ file is generated by the PE
during codesign process, so the PE must be run
first. The paragraph was updated to reflect this
change. Also, the communication settings for
the Softune debug monitor are described there
• In the chapter 6, the section "How to burn the
CPU FLASH without Devkit16" was added
• The chapter "What to do if" was updated
• The pinout of the A/D connector on page 51 has
18.12.2000
been corrected
• MCU board schematics has been corrected
89
89
89
89
V1.25
V1.26
V1.27
V1.28
Advertisement
Table of Contents
