How To Wire The One-Touch Connector Plug; Precautions For The Transition Wiring Of The One-Touch Connector For Power Supply And Fg - Mitsubishi Electric AJ65VBTCU-68DAVN User Manual

4 SETUP AND PREPARATION BEFORE OPERATION

4.10 How to Wire the One-Touch Connector Plug

4.10.1 Precautions for the transition wiring of the one-touch connector for power supply and
FG
4 - 16
This section describes the way to wire the one-touch connector plug.
Refer to section 2.4 for more information on the types and specifications of the one-
touch connector plugs which conform to the AJ65VBTCU-68DAVN.
When the power supply is connected in the transition wiring with the one-touch
connector for power supply and FG, a current flows in the inside of the module. At the
transition wiring, the maximum rated current must be lower than the following values.
Smoke and fire may occur when an overcurrent at the rated value or higher flows
intermittently for a long period of time. To avoid this, configure a safety circuit, such as
an external fuse, to protect the product.
Depending on the operation characteristics of the fuse etc., a current which exceeds
considerably the rating may flow. Therefore, in order to avoid the damage on the
module, make a selection with enough safety allowance, considering the following
maximum rated current.
MELSEC-A
4 - 16