Fault Reset; Device Calibration - Siemens Sitrans Probe LU Instruction Manual

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual

Fault Reset

Used to reset a fault message after an active fault has occurred and been corrected. A
manual reset is required only for certain faults, identified by an asterisk (*) in the General
Fault Code list on page 30.
To reset, key in the value of the fault code in question.
1. Go to
1. dentification M enu
2. Press the
3. Key in the number of the Fault Code to reset the status to normal operation.
4. Press the
Navigation mode.

Device calibration

Only four settings are required for a Quick Setup: High Calibration Point, Low Calibration
Point, High Level Point, and Low Level Point. (For an illustration, see
20.)
2.3.1. Sensor Units (default meters)
2.3.2. Calibration Type.
Values
2.3.3. Low Calibration Pt.
2.3.4. High Calibration Pt.
2.3.5. Unit [Level] (default percent)
2.3.6. Low Level Point
2.3.7. High Level Point
1. Go to
2. Go to
3. Go to
4. Go to
5. Go to
6. SITRANS Probe LU is now ready to operate.
7ML19985JB02
1. 2. Configuration
1.2.4. Reset Fault
key
key
and verify that
and enter the new value (default units are meters).
and enter the new value (default units are meters).
and enter the corresponding value in percent (default is 0).
and enter the corresponding value in percent (default is 100).
SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
to open Edit mode.
again, to accept the change and return to
calibration (preferred)
calibration
Calibration is selected.
Doc Id: VM11
Active Date: 15/12/2006
Calibration
on page
Page 47