Device - Siemens Sitrans Probe LU Instruction Manual

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual
1.2.2. Remote Lockout
Use the handheld programmer to enable or disable programming via the network
and PDM.
Hand
programmer
values
1.2.3. Factory Reset
Note:
Hand
programmer
values
Open the menu
1.2.4. Reset Fault
Resets the Fault message after an active fault has occurred and been corrected.
A manual reset is required only for the following faults:
Hand
programmer
values
Open the menu
down menu for Extended Diagnostics.
(To reset via the handheld programmer, key in the value of the fault code in
question.)
1.2.5. Menu Timeout (default 120 s)
Determines the length of time (in seconds) the device will stay in PROGRAM mode
without any key presses occurring.

1.3. Device

Manufacturer
References a specific manufacturer, usually the name of the company
responsible for the manufacture of this Field Device.
Page 74 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
Following a Master Reset, complete reprogramming is required.
Reset all parameters (except PROFIBUS address) to
PROFIBUS PA profile default values
Warm Start: restart the device (this option is rarely used)
Reset PROFIBUS address to 126
Reset to manufacturer's default values (factory settings)
Internal temperature high
Transducer temperature high
Transducer temperature low
Unlocked
Locked
and select one of the four options.
, and select the fault in question from the pull-
Doc Id: VM11
Active Date: 15/12/2006
7ML19985JB02