Activating Us320F Via The Volume Activation Management Tool (Vamt) - NEC Express5800 Series User Manual

Chapter 6 System Administration
4.3

Activating US320f via the Volume Activation Management Tool (VAMT)

You can also activate US320f using VAMT proxy activation. The VAMT host computer distributes a Multiple Activation Key
(MAK) to one or more US320f terminals and collects the installation ID (IID) from each US320f terminal. The VAMT host
computer sends the IIDs to Microsoft on behalf of the US320f terminals and obtains the corresponding Confirmation IDs
(CIDs). Then, the VAMT host computer installs the CIDs on the US320f terminals to complete the activation. To use this
activation method, only the VAMT host computer needs to be enabled to access the Internet. For details about the VAMT,
see the Microsoft documentation.
To perform VAMT proxy activation, it is necessary to register a firewall exception and set the registry on US320f terminals
in advance to allow communication with the VAMT among subnets. Disable UWF to keep the setting also after the restart
of US320f, and then perform the following steps:
1. Sign in to US320f as an Administrator.
2. If your device is in a workgroup, you may need to disable Remote UAC. Open a command prompt with
administrator user rights and type the following to disable Remote UAC:
reg add HKLM\SOFTWARE\Microsoft\Windows\CurrentVersion\Policies\system /v
LocalAccountTokenFilterPolicy /t REG_DWORD /d 1 /f
3. Type the following to enable the Remote Administration exception:
netsh advfirewall set service RemoteAdmin enable
4. Type the following to enable WMI traffic at a command prompt by using a WMI rule:
netsh advfirewall firewall set rule group="windows management instrumentation (wmi)" new enable=yes
5. Type the following to establish a firewall exception for DCOM port 135:
netsh advfirewall firewall add rule dir=in name="DCOM" program=%systemroot%\system32\svchost.exe
service=rpcss action=allow protocol=TCP localport=135
6. Type the following to establish a firewall exception for the WMI service:
netsh advfirewall firewall add rule dir=in name ="WMI" program=%systemroot%\system32\svchost.exe
service=winmgmt action = allow protocol=TCP localport=any
7. Type the following to establish a firewall exception for the sink that receives callbacks from a remote device:
netsh advfirewall firewall add rule dir=in name ="UnsecApp"
program=%systemroot%\system32\wbem\unsecapp.exe action=allow
8. Type the following to establish a firewall exception for outgoing connections to a remote device that the local
computer is communicating with asynchronously:
netsh advfirewall firewall add rule dir=out name ="WMI_OUT" program=%systemroot%\system32\svchost.exe
service=winmgmt action=allow protocol=TCP localport=any
216
Express5800/US320f User's Guide
4. Activating US320f