Available Settings - NEC Express5800 Series User Manual

Chapter 4 Configuring Client Settings with Atrust Client Setup
2.2

Available Settings

Tab Setting
System Password
Firmware
Update
Snapshot
Appliance
Mode
UWF
Advanced
84
Icon Description
Click to set a password to access Atrust Client Setup.
You can enable or disable remote assistance and set a
password here.
Click to update firmware locally with the help of a
remote management computer. This feature is only
applicable when the client is managed by the Atrust
Device Manager console.
Click to take a snapshot (system image) of the client for
mass deployment.
Click to enable/disable the Appliance mode to
allow/disallow the automatic RDP / Citrix ICA /
VMware View sessions. In Appliance mode, the client
starts up with the desired RDP / Citrix ICA / VMware
View session and shuts down when the user logs out.
Click to configure UWF (Unified Write Filter) settings.
Enabling UWF option will redirect all writes targeted
for disk volumes to a RAM cache. All system changes
will only affect the session where the changes are
made. After restart, all changes will be discarded.
You can automatically register US320f in Atrust Device
Manager and set the stealth mode to disable manual
detection of US320f by IP range from Atrust Device
Manager.
Note Atrust Device Manager is a remote and mass client management console, helping you remotely
manage a large number of endpoint devices in a desktop virtualization infrastructure. For more
information about Atrust Device Manager, refer to the User's Guide for Atrust Device Manager.
Express5800/US320f User's Guide
2. Configuring System Settings
Section page
 Chapter 4 "2.3 Setting a Password
to Access Atrust Client Setup"
 Chapter 4 "2.4 Configuring
Shadow Settings for Remote
Assistance"
 Chapter 4, "2.5 Updating
Firmware from the Management
Computer".
 Chapter 4, "2.6 Taking Snapshots
for Mass Deployment".
 Chapter 4, "2.8 Enabling or
Disabling the Appliance Mode"
 Chapter 4, "2.9 Configuring UWF
(Unified Write Filter)".
 Chapter 4, "2.10 Enabling /
Disabling Automatic Registration
and Stealth Mode"