Siemens SIMATIC Ident Function Manual page 101

Address spaces of the MIFARE transponder (MDS E)
The address spaces of the MIFARE transponders (MDS E) are illustrated below. These
transponders can be used in the RF300 Ident System.
The UID of the transponders is permanently addressed and can only be read out in full.
• Start address of the UID: 0xFFF0
• Length of the UID: 0x0008
Table 4- 91 Address spaces of the MIFARE transponder (MDS E)
User memory
752 bytes EEPROM
Address spaces of the RF600 transponders
With the RF61xR/RF650R/RF68xR readers, the user data, TID, EPC and passwords are
read out via the relevant memory banks. To read out the required data, the relevant
memory bank must be selected.
The table above shows the area and length of the user data ("USER" column). You can
read out the EPC ID using an inventory command. As an alternative, you can also read
out the EPC ID using a Read command to memory bank 1, start address 0x04.
Figure 4-32 Memory configuration
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
Transponder type
MDS E600 / MDS E611 /
MDS E623 / MDS E624
Configuring the instructions
4.8 Transponder addressing
Address area (hex, 16-bit)
0x0000 ... 0x02EF
101