Error mes-
Description
sage
(hex)
0xE4FE0100
Short circuit or overload of the 24 V outputs
•
The reader is using too much current.
•
The reader cable is causing a short-circuit.
Possible consequences:
•
The affected output is turned off
•
All outputs are turned off when total overload occurs
•
A reset can only be performed by turning the 24 V voltage off and on again
•
and then starting "Reset_Reader"
0xE4FE0300
•
Error in the connection to the reader; the reader is not answering.
The cable between the communications module and reader is wired incorrectly or there is a
–
cable break
The 24 V supply voltage is not connected or is not on or has failed briefly
–
Automatic cutout on the communications module has responded
–
Hardware defect
–
Another reader is in the vicinity and is active
–
Execute "INIT"/"WRITE-CONFIG" after correcting the error
–
•
The antenna of the reader is turned off. A tag command to the communications module was start-
ed in this status.
Turn on the antenna with the command "Antenna on/off."
–
The antenna is turned on (off) and has received an additional turn-on (turn-off) command
–
•
The mode in the "SET_ANT" command is unknown
•
The antenna on the reader is turned off or the antenna cable is defective
0xE4FE0400
•
The buffer on the communications module or reader is not adequate to store the command tempo-
rarily.
•
Freeport: New data was received before existing data was retrieved.
Scan mode: The latest data is lost.
–
With the "Write" command, the oldest acknowledgments are lost without an error message being
generated.
0xE4FE0500
The buffer on the communications module or reader is not adequate to store the data temporarily.
0xE4FE0600
The command is not permitted in this status or is not supported.
Possible causes:
•
The "INIT" command has been concatenated.
•
RF600: Command repetition was started without "Presence mode".
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
5.1 Error messages from the Ident profile / Ident instructions
Diagnostics and error messages
107