Siemens SIMATIC Ident Function Manual page 79

Parameter
LEN_ID
TXREF
Table 4- 58 Structure of the data attachment for the "FORMAT" command with normal address-
Byte
Value
Table 4- 59 Explanation of the structure of the data attachment for the "FORMAT" command
Byte
Bytes 1...8
Byte 9
Byte 10
Byte 11
Byte 12
Byte 13
Byte 14
Byte 15
Table 4- 60 Memory sizes of the transponders
20 bytes
8 KB
32 KB
64 KB
752 bytes
* The OTP memory is not initialized with this command.
)
Table 4- 61 PUT (not with RF600)
Parameter
CMD
OFFSETBUFFER
LEN_DATA
TXREF
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
Value / description
Length of the EPC-ID/UID
Parameter data to be written
ing
1...8 9 10
0x00 0x06 0x03
Description
Reserved for security code (must be assigned "0", since SIMATIC RFID has had
no code previously)
Length of the following data, here 6
Permanently set to "0x03"
Permanently set to "0x00"
"INIT" value: The data area of the transponder is written with this value (hex
format).
Permanently set to "0x00"
Memory size of the transponder (end address + 1; high byte, hex format)
Memory size of the transponder (end address + 1; low byte, hex format)
Transponder type
RF300 EEPROM
RF300 FRAM *)
RF300 FRAM *)
RF300 FRAM *)
MOBY E EEPROM
Value / description
0x65
Offset in the "TXREF" send buffer
Length of the parameter data to be sent
Parameter data to be written
Configuring the instructions
4.6 Programming the Ident profile
11 12 13
0x00 INIT- 0x00
Wert
Memory size
00 14
20 00
80 00
FF 00
02EF
14 15
MSB LSB
INIT duration
approx. 0.2 s
0.9 s
3.6 s
7.2 s
approx. 1.5 s
79