Panasonic FP7 Series User Manual page 50
Cpu unit
Hide thumbs
Also See for FP7 Series:
- Command reference manual (1222 pages) ,
- User manual (275 pages) ,
- Additional functions manual (45 pages)
Table of Contents
Advertisement
2.2 CPU Unit (CPS2R)
(6) COM0 port terminal
Three-wire RS-232C port.
(5) (6) Terminal layout
(Note 1)
Each terminal of the COM.0 port is insulated from the internal circuit. Also, theSG terminal (COM.0
port) is insulated from the 0V terminal (Power supply output for GT).
(7) Unit connector
Used for connecting an I/O unit or intelligent unit. An end unit is fitted when the unit is shipped.
(8) USB port
Used for connecting with a PC on which tool software is used.
(9) Mode switch
Switch position
RUN (left)
PROG. (right)
(Note 1)
Whether the switch is set to RUN or PROG., the mode can be switched through remote operation from
the tool software. When power is turned on again, it operates in the mode set on the switch.
2-6
Sets to RUN mode. The program is executed and operation begins.
Sets to PROG mode.
Operation mode
WUME-FP7CPUH-09
Advertisement
Table of Contents
