Transmission From An Sd Memory Card To The Execution Memory - Panasonic FP7 Series User Manual
Cpu unit
Hide thumbs
Also See for FP7 Series:
- Command reference manual (1222 pages) ,
- User manual (275 pages) ,
- Additional functions manual (45 pages)
Table of Contents
Advertisement
5.4 SD Memory Card Operation
3.
Set the card operation switch to "CARD".
4.
Close the cover and power on the unit.
The auto execution file "autoexec.fp7" and the comment file "comment.fp7" of the project
saved in the SD memory card are transmitted to the execution memory RAM. Transmission
of the project takes place when the unit is powered on or the mode switch is set to "RUN".
Operations during SD Memory Card Operation
If the following steps are taken, the unit runs in the "SD memory card operation" mode. Until the
unit is powered off, it cannot be switched into RAM/ROM operation.
Example 1:
1. Power on the unit while the card operation switch is set to "ROM".
2. Set the card operation switch to "CARD".
3. Set the mode switch to "RUN".
Example 2:
1. Power on the unit while the card operation switch is set to "CARD".
2. Set the mode switch to "RUN".
● Online editing cannot be performed. A protection error occurs.
5.4.5 Transmission from an SD Memory Card to the Execution Memory
Insert an SD memory card, and set the mode switch to "COPY", in order to transmit a project
saved in the SD memory card to ROM1 and write it in as an execution project.
■
Switch setting conditions
Mode switch
Card operation switch
5-12
Switch
PROG. → COPY (momentary)
CARD
Setting
WUME-FP7CPUH-09
Advertisement
Table of Contents
