Technical Information
2.8
Starting Program
The starting program operates at the time of commissioning under the
following circumstances:
No defective NTCs
The temperature read by both the ambient air and SmartFresh NTCs
is greater than 41°F (5°C)
The appliance door is closed
In the starting program, each of the following components is run for 5
seconds, one after the other:
Refrigerant stop valve
Icemaker
Freezer evaporator fan
Refrigerator evaporator fan
Condenser fan
Air flap motor
Interior heater
Drain channel heater, freezer
Drain channel heater, refrigerator
Defrost heater, freezer
Defrost heater, refrigerator
Freezer compressor
Refrigerator compressor
2.9
MasterCool Controls
Figure 030-4: MasterCool Controls
1 Access button (thermometer)
2 Refrigerator compartment
3 Left SmartFresh compartment
4 Right SmartFresh compartment
5 Freezer
6 Temperature display and adjustment
2.10
Display Icons
Only the icons that can be activated are lit (backlit, white). When a selected
icon or function is activated, the background light of the icon becomes yellow.
Touching the icon again turns the function off, and the background light
reverts to white. If no icon is touched after 4 seconds, then all icons will fade
except for the thermometer.
7 Food type (for SmartFresh compartments)
8 SuperCool
9 Icemaker
10 Temperature/door alarm
11 Water filter change indicator
18
KF 18xx/19xx