Result Page - Epson TM-P20II Reference Manual

10.5.2.1.3 Button
The following table shows the buttons on the page.
Items
"OK"
"Restore Default Settings"
When the "OK" button is pressed, Web Config displays a pop-up window with the following message if it recognizes an error in
the entered value.
Items
"Invalid value below."
"Password and confirm password do not match."

10.5.2.2 Result Page

The result message is shown in the main frame after the "OK" button is pressed.
10.5.2.2.1 Image
10.5.2.2.2 Setting Result
Items
"Setup complete."
"Failed to make the settings."
"The password you entered is incorrect."
"The password does not meet the password
policy requirements. Check the requirements."
"Setup failed."
Table 10-155 Button
Description
Button at the bottom of the page
If pressed, Web Config restores the
setting values to the factory defaults.
Table 10-156 Error Pop-up
When the format of the entered user name or password is not correct,
this message is shown.
When new password and the confirmation password do not match,
this message is shown.
Figure 10-62 Image
Table 10-157 Result
This message is shown when the settings are completed.
After that, Web Config reloads the page and displays the product
status page.
If an administrator was logged on previously, Web Config maintains
administrator logon mode. If a user other than an administrator was
logged on, Web Config exits administrator logon mode.
This message is shown if the current password entered by the user is
incorrect.
None of the setting items on this page are applied to the printer.
This message is shown if setup fails due to a violation of the Password
Policy.
This message is shown if setup fails for a reason other than those
described above.
Condition
-
Displayed only on models that
support the initial value for the
administrator password.
Description
Setting Result
Description
133