Confirm Page; Result Page - Epson TM-P20II Reference Manual

10.3.4.2 Confirm Page

10.3.4.2.1 Image
10.3.4.2.2 Display Items
The settings that were entered on the previous page are shown for confirmation after the "Change the following settings" message.
The following message is shown below the confirmed settings: "Communication will stop temporarily to enable the new settings.
You will not be able to access the network immediately after the settings are changed."
10.3.4.2.3 Button
The following table shows the buttons on the page.
"OK"
"Back"

10.3.4.3 Result Page

The result page is shown in the main frame after the "OK" button is pressed. An error page is shown when Wi-Fi LAN mode is set
to IEEE802.11g in the printer. The page is shown when "Delete" is pressed on the previous page.
10.3.4.3.1 Image
10.3.4.3.2 Setting Result
"Shutting down."
"Restarting communication may take a few minutes."
"If you want to change the settings, close the Web
Config and check your IP address. Then enter your IP
address in the browser to restart the Web Config."
"Setup complete."
Figure 10-18 Confirm Page
Items
Table 10-44 Setting Result
Items
Table 10-43 Button
- Button at the bottom of the main frame to perform settings.
- Button at the bottom of the main frame to go back to the
previous page.
Figure 10-19 Result Page
This message is shown if setup is successful.
This message is shown when the delete operation is completed
successfully.
Display Items
Button
Description
Setting Result
Description
66