Result Page - Epson TM-P20II Reference Manual

10.3.3.2.2 Input Information
Items
"Confirm the following settings."
"Communication will be shut down temporarily
to enable the new settings. You cannot access
the network immediately after the settings are
changed."
10.3.3.2.3 Button
There is a button to proceed to the remaining settings based on the values entered on this page, and a button to go back to the
previous page.
Items
"OK"
"Back"

10.3.3.3 Result page

The following figure shows the page that is displayed after the network settings are processed. The content of the Result page will
vary based on the result (success or failure).
10.3.3.3.1 Image
10.3.3.3.2 Setting Result
Items
"Shutting down."
"Restarting communication may take a few
minutes."
"If you want to change the settings, close the
Web Config and check your IP address. Then
enter your IP address in the browser to restart the
Web Config."
"Setup failed."
Table 10-37 Input Information
This message is shown at the top of the page, followed by the setting
items and their values.
This message is shown at the bottom of the page.
Table 10-38 Button
This button is used to apply the entered values to the system shown
on the Confirm Wired LAN Settings page. If pressed, Web Config goes
to the Result page.
This button is used to go back to the Wired LAN Settings page.
Figure 10-16 Result page
Table 10-39 Setting Result
This message is shown if setup is successful.
This message is shown if Wi-Fi/Network setup fails.
Description
Description
Setting Result
Description
63