Confirm Wi-Fi Setup Page - Epson TM-P20II Reference Manual

When the "Apply" button is pressed, Web Config displays a pop-up window that shows the following message if it recognizes an
error in the entered value.
"Invalid value below."
"Passwords you entered do not match."

10.3.2.4 Confirm Wi-Fi Setup Page

10.3.2.4.1 Image
10.3.2.4.2 Display Items
"Confirm the following settings."
"SSID"
"Communication Mode"
"Security Level"
"Communication will be shut down temporarily to
enable the new settings. You cannot access the
network immediately after the settings are changed."
"Security Level" is determined by the values on the Wi-Fi Setting page.
SSID
- Select "Enter SSID".
- Select from list.
Items
Figure 10-12 Confirm Wi-Fi Setup Page
Table 10-31 Display Items
Items
Table 10-32 Value for Security Level
the values of Wi-Fi Setting page
Security Level of selected SSID
-
- "Unknown"
- Others
Table 10-30 Error Pop-up
This message is shown when the value entered for SSID, Password,
or Confirm Password is invalid. The item names of the invalid
values are shown under the message in the left cell. If there are two
or more items whose values were invalid, those items are listed line
by line.
This message is shown if the values entered for Password and
Confirm Password do not agree.
This message is shown at the top of the page.
The value entered on the Wi-Fi Setup page is shown.
The value entered on the Wi-Fi Setup page is shown.
The value entered on the Wi-Fi Setup page is shown.
This message is shown at the bottom of the page.
Length of Security Level
0
5
Others
0
10 (hexdecimal)
26 (hexdecimal)
5 (not hexdecimal)
13 (not hexdecimals)
Others
-
Description
Display Items
Button
Description
Security Level of Confirm
Wi-Fi Setup Page
"None"
"WEP-64bit(40bit)"
"Unknown"
"None"
"WEP-64bit(40bit)"
"WEP-128bit(104bit)"
"WEP-64bit(40bit)"
"WEP-128bit(104bit)"
"Unknown"
- Select Security Level
60