16-Channel Relay Multiplexer Error Messages - HP E1343A User Manual

Table C-1. 16-Channel Relay Multiplexer Error Numbers/Messages
Number Title
-211 Trigger ignored
-213 Init Ignored
-224 Illegal parameter value
+1500 External trigger source
already allocated
+2000 Invalid card number
+2001 Invalid channel number
+2006 Command not supported
on this card
+2008 Scan list not initialized
+2009 Too many channels in
channel list
+2012 Invalid Channel Range
+2600 Function not supported
on this card
+2601 Channel list required
Appendix C
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
16-Channel Relay Multiplexer
Figure C-1 lists the error messages associated with the multiplexer modules
programmed by SCPI. See the appropriate Mainframe manual for a
complete list of error messages.
Trigger received when scan not enabled. Trigger received after scan
complete. Trigger too fast.
Attempting to execute an
progress.
Attempting to execute a command with a parameter not applicable to
the command.
Assigning an external trigger source to a switchbox when the trigger
source has already been assigned to another switchbox.
Addressing a module (card) in a switchbox that is not part of the
switchbox.
Attempting to address a channel of a module in a switchbox that is not
supported by the module (e.g., channel 99 of a multiplexer module).
Sending a command to a module (card) in a switchbox that is
unsupported by the module.
Executing a scan without the
Attempting to address more channels than available in the switchbox.
Invalid channel(s) specified in
Attempting to begin scanning when no valid channel list is defined.
Sending a command to a module (card) in a switchbox that is not
supported by the module or switchbox.
Sending a command requiring a channel list without the channel list.

16-Channel Relay Multiplexer Error Messages

Appendix C
Error Messages
Potential Cause(s)
INIT command when a scan is already in
command.
INIT
<channel_list> command.
SCAN
85