Siemens SICHARGE UC Operating Instructions Manual page 52

Installation
5.3 Wall/ceiling mounting
Required tools and fasteners
To mount the SICHARGE UC Dispenser, you need the following tools:
• Torque wrench
• Socket: Hexagonal
The mounting material is not included in the scope of delivery.
We recommend the following fixing material for mounting the SICHARGE UC Dispenser to the
mounting surface:
• 4 bolt anchors M12
For example, FISCHER FAZ ΙΙ 12/20 H A4 cap nut
• 4 washers M12
• 4 nuts M12
• Screw lock
For example, LOCTITE 243
Mounting the SICHARGE UC Dispenser
To position the SICHARGE UC Dispenser on the mounting surface, follow these steps:
1. Position the SICHARGE UC Dispenser on the mounting surface using the bottom bolt
anchor
2. Check whether the alignment of the SICHARGE UC Dispenser above the bottom bolt
anchor of the mounting surface is correct
3. Lower the SICHARGE UC Dispenser onto the bottom bolt anchor
4. Place the washers on the bottom bolt anchors
5. Screw the cap nuts onto the bottom bolt anchors
6. Remove the lifting gear and the shackles from the top mounting rail
7. Slide the SICHARGE UC Dispenser onto the top bolt anchor up to the mounting surface
8. Place the washers on the top bolt anchors
9. Attach a bolt lock to the top bolt anchors. We recommend LOCTITE 243.
10. Screw the cap nuts onto the top bolt anchors
11. Unscrew the bottom cap nuts somewhat
12. Attach a bolt lock to the bottom bolt anchors. We recommend LOCTITE 243.
13. Tighten all nuts with the tightening torque of the bolt anchors as per the manufacturer
instructions
52
SICHARGE UC Dispenser
Operating Instructions, 06/2023, A5E50235695-AE