When Os Is Started - NEC Express5800/R120e-1M Instruction Manual

Chapter 1 Maintenance
5.4

When OS is Started

[?] Unable to start OS
Has the BIOS configuration of the RAID Controller changed?
→
Set the correct BIOS configuration with a RAID Configuration Utility (WebBIOS).
Is the RAID Controller recognized by POST?
→
Turn on the power after the RAID Controller is recognized as being connected successfully.
→
If the RAID Controller is not recognized as being connected successfully, the RAID Controller may be
faulty. Contact the maintenance service company with which you signed up or the dealer where you
purchased the product.
Is RAID Controller installed firmly straight into the PCI slot?
→
Install the RAID Controller properly.
Is the RAID Controller mounted on the PCI slot for which the mounting is restricted?
→
Check the mounting restrictions of the server and then mount the RAID Controller on the correct slot.
If the RAID Controller is not recognized as connected although the above action has been taken, the
RAID Controller may be faulty. Contact the maintenance service company with which you signed up or
the dealer where you purchased the product.
Are Hard Disk Drives properly installed?
→
Install Hard Disk Drives properly.
Is SAS cable connected to Hard Disk Drive correctly?
→
Connect the SAS cable properly.
If the SAS cable is not recognized as connected although the above action has been taken, the Hard
Disk Drive may be faulty. Contact the maintenance company with which you signed up or the dealer
where you purchased the product.
Is the EXPRESSBUILDER DVD inserted?
→
Eject the EXPRESSBUILDER DVD and reboot.
Is a cartridge inserted into N8151-86 with built-in RDX (USB)?
→
Either remove the cartridge or change the boot order in BIOS Setup.
Is Disk Array unit connected to the PCI card?
→
Change the boot device configuration from HDD Drive BBS Priorities of the BIOS Setup Boot menu.
[?] OS does not start with the /3GB switch
→
In Windows Server 2003 x86
In this case, please adjust the capacity of the user mode area using the /userva switch in reference to
the following URL.
http://support.microsoft.com/kb/316739/en-us
34
system often fails to start the OS with the /3GB switch.
,
Express5800/R120e-1M, R120e-2M Maintenance Guide
5. Troubleshooting