Steps
1. To remove the dummy metal bracket, insert a star-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system..
NOTE:
Applies if you are upgrading the system that did not have these optional modules.
2. Connect the optional Type-C-module cables to their connectors on the system board.
3. Insert the optional Type-C module into the slot on the chassis.
4. Replace the two (M3x3) screws that secure the optional Type-C module to the chassis.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
DP module
Removing optional DisplayPort module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
112
Removing and installing Field Replaceable Units (FRUs)
After working inside your
before working inside your
computer.
computer.