Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Route the intruder cable through the retention clip.
3. Connect the intruder cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
System fan
Removing the system fan
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following images indicate the location of the system fan and provides a visual representation of the removal procedure.
82
Removing and installing Field Replaceable Units (FRUs)
after working inside your
Before working inside your
computer.
computer.