Steps
1. Insert the rubber grommets through the holes on the chassis.
2. Insert the rubber grommets through the holes on the system fan.
3. Pull the rubber grommets and push the system fan towards the chassis until it clicks in place.
4. Connect the system fan cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
after working inside your
computer.
Power-supply unit
Removing the power-supply unit
CAUTION:
The information in this section is intended for authorized service technicians only.
84
Removing and installing Field Replaceable Units (FRUs)