Steps
1. Loosen the two captive screws that secure the VR heat sink to the system board.
2. Lift the VR heat sink off the system board.
Installing the VR heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the VR heat sink and provide a visual representation of the installation procedure.
Steps
1. Align and adhere the VR heatsink on the system board.
2. Tighten the two captive screws that secure the VR heatsink to the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
96
Removing and installing Field Replaceable Units (FRUs)
after working inside your
before working inside your
computer.
computer.