Table of Contents
Advertisement
The economy function is valid for the
following temperature setting values.
Indoor Temperature 18°C (64°F) -
30°C (86°F) - Outdoor Temperature
21°C (70°F) - 32°C (90°F)
This function is only active in cooling
mode.
The product capacity may be
reduced when the Economy function
is selected.
If the "S
" button (
while the conomy function is
running, the economy function is
switched off and the ilent function is
activated.
Silent Function (
It reduces the volume level of the outdoor
unit in order to avoid potential noise claims
from neighbours. The reduction in sound
level provided by the silent function is up to
3 dB less than normal operation.
1.
To operate the product, press the " "
button.
It is available under cooling, heating,
2.
auto-operation mode.
Press the "S
3.
silent function.
Press the "S
4.
switch off the silent function.
Controller display
The silent function is valid between the
following temperature setting values.
During cooling:
- Indoor 18°C (64°F) ~ 30°C (86°F)
Outdoor 18°C (64°F) ~ 43°C (109°F)
During heating:
- Indoor 16°C (60°F) ~ 30°C (86°F)
Outdoor 6°C (43°F) ~ 24°C (75°F)
(
) is pressed
)
" button (
)
) to start the
" button (
) again to
If the "E
pressed while the silent function is
running, the silent function is switched
off and the conomy function is
activated.
If any other mode or
preferred while the ilent function is
active, the ilent function is disabled.
The capacity of the product may be
reduced when the silent function is
selected.
Setting the clock (
To set the clock, press and hold the
1.
"
" button (
the digits indicating the clock will
flash.
Controller display
Set the clock using the " " buttons.
2.
(If you press the buttons for more
than 3 seconds, it will change in units
of 10 min.)
Press the "
3.
finish setting the clock. After setting is
done, the clock symbol will remain
fixed on the display.
Degrees cannot be changed until the
clock setting is complete Press the
"
" button (
clock setting function. In this case,
the time when you press the
"
" button (
4.
Repeat steps 1,2,3 to change the set
clock again.
Clock format is 24-hour clock.
It is very important to set the time
correctly as the program setting you
will adjust the air conditioner with will
be based on the clock of the remote
control.
The clock can be set when the
controller is off.
22
" button (
(
) is
function is
)
) for 3 seconds,
" button (
(
)
) to
) )
) again to exit the
(
) will be saved.
Advertisement
Table of Contents
Troubleshooting
