Sleep Mode Function - Beko 71261 AL Owner's Manual

Sleep Function
This function prevents your room from
cooling down or warming up extremely
during sleep. When the sleep setting
function is selected while the air conditioner
is in cooling or heating mode, the unit
provides optimal comfort and stops after
the set time.
To operate the product, press the "
button.
Select the desired mode by pressing
one of the "Cool" (
"Mode" ( ) buttons.
3.
Set the A/C to a desired temperature.
See "Temperature adjustment"
4.
Press the "Sleep" button (

sleep mode function.

Each time the "Sleep" (
pressed, the operating time of the
selected mode will be added by 1 hour.
- You can set the sleep mode between
1-7 hours.
- If 7 hours are exceeded, the system
will automatically exit "Sleep" mode.
Controller display
Please select the appropriate duration
for sleep mode. (Cooling your room for
long periods is not good for your health.)
While in sleep mode function, after 30
minutes, the room temperature set value
will be 1° C higher than the temperature
you have set in Cooling mode, and 2° C
higher after 1 hour.
While in sleep mode, after 60 minutes,
the room temperature set value will be
1° C lower than the temperature you
have set in Heating mode, and 2° C
lower after 2 hours.
Sleep mode can only be set while the
product is operating.
"
), "Heat" ( ) or
) to start the
) button is
Timer On/Off function
Allows the air conditioner to turn on or off
automatically when you are away from
home or asleep.
Timer On ( ( ( )
To turn on the air conditioner automatically,
you can set the program by performing the
following operations.
Example: Let the air conditioner switch on
at 10:00 in the morning.
Press the "
"Network" symbol starts to flash.
On,
and exit from these
combination under the timer button.
Sequencing is as shown in the table.
Controller display
Set the clock using the "
buttons. (Each time you press the button it
will change in units of 10 min.) If the button
is pressed and held down for 3 seconds,
the 10 minute transitions will be run faster.)
Controller display
Press the "
setting the clock When the setting is
complete, the "
the remote control and the current time will
be displayed.
23
" button (
Off, Cancel functions
are available as a
Open
Off
Cancel
Exit
"
" button ( ) to finish
" symbol will appear on
) until the