Automatic Start; Operating The A/C With The Remote Control; Test Operation Mode - Beko 71261 AL Owner's Manual

Automatic start

When the power is back following an
power outage, the air conditioner starts
operating using the settings before the
power outage thanks to the automatic
start feature. At the first start-up, the fan
runs at the lowest speed and the
compressor is activated after 2.5-3
minutes. The fan speed is automatically
adjusted to the previous settings as soon
as the compressor is activated.
Automatically start the air
conditioning system
When the air conditioning system is
switched on again after a power failure,
this function returns the previous settings.
This function is a factory default setting.
Cancel automatic restart
1 Open the horizontal
Press the power button and hold for 6
2
seconds.
- The device will beep twice and the light
will flash 4 times.
* Feature can be changed according to model type.
-
To reactivate this function, press and
hold the On/Off button for 6 seconds.
The device will beep twice and the light
will flash 4 times.
If you press and hold the On/Off button
for 3-5 seconds instead of 6 seconds,
the unit will initiate the test operation.
During testing, the unit blows out
strong air current for 18 minutes for
cooling and then returns to factory
default settings.
Operating the A/C with the
remote control
Use the On/Off button to turn on the air
conditioner when there is no remote
control. However, the fan speed is set
to high.
1 Open the horizontal
2 Press the on/off button.
.
Operating mode
Indoor fan speed
Temperature

Test operation mode

For test operation mode, press and
1.
hold the manual operation button on
the indoor unit for about 3 seconds.
To cancel the test run mode, press the
manual start button or the "
2.
on the remote control.
In this position, the
appear on the air conditioner operating
status display.
The air conditioner operates for 18
minutes at maximum fan speed
regardless of room temperature in
cooling mode during test operation.
If a signal is received from the remote
control while the unit is running in test
operation mode, the air conditioner will
operate according to the control
settings.
25
Cooling Dehumidifying
High
22°C
This function may not be included
or not work on some products.
rol. r rol.
.
Heating
High High
23°C 24°C
" button
symbol will
d d