Supported Paper; Moving And Transporting The Printer; Moving The Printer - Epson SureColor SC-F6300 Series User Manual

SC-F6300 Series User's Guide

Supported Paper

The following paper can be used with the printer. Print
quality is greatly affected by the type and quality of paper
used. Choose a paper type suited to the task at hand. For
information on use, see the documentation supplied
with the paper or contact the manufacturer. Print a test
run and check the results before purchasing paper in
large quantities.
Roll Paper
Roll core size 2 or 3 inch
Roll outer 150 mm or less
diameter
* 254 mm (10 inches) to 1,118 mm (44
Width
inches)
Thickness 0.08 to 0.5 mm
* 432 mm (17 inches) to 1,118 mm (44 inches) when the
optional auto take-up reel unit is installed.
Appendix
Moving and Transporting
the Printer
This section describes how to move and transport the
product.

Moving the Printer

This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors, to another building,
or between non-level floors.
"Moving the Printer" on page 101
U
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
Getting Ready
Make the following preparations in advance before
moving the printer.
❏ Turn off the printer and remove all cables.
❏ If the printer has a Waste Ink Bottle, remove it
before continuing.
❏ Remove any paper.
❏ Remove any optional components if they are
installed.
❏ Unlock the stand.
Post-Move Setup
After moving, make the following settings to get ready
for printing.
❏ Check that the location is appropriate for
installation, and set up the printer.
U Setup Guide(booklet)
❏ Plug in the power cables and turn the printer on.
U Setup Guide(booklet)
101