Epson SureColor SC-F6300 Series User Manual page 76

SC-F6300 Series User's Guide
E
Install the chip unit that comes with the new ink
pack.
During installation, check to ensure that the
labels on the slider and the chip unit are the same
color.
F
Hold the slider level horizontally and insert it.
Close the side cover.
c
Important:
Do not push the slider in with excessive force.
This can cause damage.
Maintenance
G
Shake the new ink pack for 5 seconds 15 times
horizontally in approximately 5 cm movements
as shown in the illustration.
H
Check that no warnings or errors are displayed
on the control panel screen before opening the
inlet cover of the slider.
If an error or a warning is displayed, follow the
messages to resolve the error or warning, and
then proceed with the following operation.
I
Remove the ink inlet cap from the ink tank.
The method for removing the ink inlet cap differs
depending on the type of ink being refilled.
c
Important:
Remove the ink inlet cap slowly. If you remove
the cap too quickly, ink may splatter.
76