Settings For Loaded Paper - Epson SureColor SC-F6300 Series User Manual

SC-F6300 Series User's Guide
E
Raise the roll lock lever.
F
Holding the paper by the roll adapters, move the
roll to the roll rest.
G
Lift the adapter lock levers to release the roll
paper adapters.
H
Remove the roll paper adapters.
After rewinding the roll paper carefully, store it
in the original package.
I
Close the roll paper cover.
Basic Operations

Settings for Loaded Paper

When you have finished loading the paper, follow the
instructions on the control panel to make settings for
the loaded paper.
1. Set the paper type
This is the most important setting for optimum print
results. Failure to select an appropriate paper type
that matches the loaded paper may cause problems
such as wrinkling or scuffing.
Remaining Setup
The factory default setting is On. You can change this
to Off.
2. Set the paper length
The approximate amount of paper remaining is
determined from the length set here and the amount
of paper used during print jobs. The amount of paper
remaining is displayed in the information area on
the . tab.
This setting screen is not displayed when Remaining
Setup is set to Off.
Buttons that are used in the following settings
A
The previous settings for the paper type and
amount remaining are displayed.
Check that the print settings for the loaded paper
use the paper setup number that you configured.
If you have loaded new paper that has not been
setup, select an unassigned number, finish
feeding the paper, and then perform paper setup.
28