Sanyo CAR-5040 Series User Manual page 113

Table 5.7.1 Field description of Network Interface Configuration
Field Name Description
Network Interface Settings
MAC Address Displays the MAC address of the interface that uniquely identifies this device
on the network. This is read-only information.
Auto Negotiation Toggles on/off the auto negotiation of the connection speed and duplex mode.
This only applies if in dedicated NIC mode. The preset value is On.
Network Speed Toggles the network speed to 10Mb or 100Mb to match your network
environment. This option only applies in dedicated NIC mode and is not
available if auto negotiation is set to On.
Duplex Mode Toggles the duplex mode to Full or Half to match your network environment.
This option only applies in dedicated NIC mode and is not available if auto
negotiation is set to On.
General Settings
Enable Dynamic Enables user to register this firmware address with the DNS when the checkbox
DNS is checked.
Use DHCP for DNS Enables or disables the DHCP to acquire the DNS Domain Name. If checked, the
Domain Name DNS Domain Name field is disabled, and the DNS Domain Name will be
acquired from the DHCP server.
Respond to ARP Enables to open Address Resolution Protocol (ARP) proxy respond.
IPv4 Settings (Enter 0.0.0.0 to clear an IPv4 field. Empty strings are not allowed for IPv4 addresses.)
Enabled Enables the availability of the IPv4 protocol when checked, and enables all
other fields in this section except Use DHCP to obtain DNS server addresses.
Use DHCP When enabled (checked), the IP address for the Appliance management NIC is
obtained from the DHCP server and the IP Address, Subnet Mask and Gateway
fields are deactivated. Use DHCP must be checked before you enable the Use
DHCP to obtain DNS server addresses setting. (The default value is Off.)
IP Address If Use DHCP is enabled (checked), the IP Address value is automatically
supplied from the DHCPv4 server. If disabled, the IP Address value must be
entered manually using format 192.168.1.1.
Subnet Mask If Use DHCP is enabled (checked), the Subnet Mask value is automatically
supplied from the DHCPv4 server. If disabled, the Subnet Mask value must be
entered manually using format 255.255.255.0.
Gateway If Use DHCP is enabled (checked), the Gateway value is automatically supplied
from the DHCPv4 server. If disabled, the Gateway value must be entered
manually using format 192.168.1.254.
Use DHCP to obtain If enabled (checked), the DNS server address is obtained from the DHCPv4
DNS server server. Use DHCP must be checked before you enable the Use DHCP to obtain
CAR-5040 Series User's Manual
All manuals and user guides at all-guides.com
頁 113