Sanyo CAR-5040 Series User Manual page 103

The following steps will show how to configure Alert Destination from WebGUI:
Step 1. Log in to the LOM as Administrator to reach the WebGUI.
Step 2. From the Event Management tab, select Trap Setting.
User will see the Trap Settings page screen as Fig. 5.6.1.3. The detail description of Trap
Setting format will show in Table 5.6.1.2.
Step 3. Click the IPv4/IPv6 Destination enabled button to enable Trap setting.
Step 4. Edit the destination IP for the alert.
Click "Apply Changes" button to save setting.
Step 5.
Field Name Description
Enable Enables or disables up to four IPv4/ IPv6 destination addresses.
IPv4 Address Configures up to four IPv4 addresses. Allows only numerical values from
0-255 using the pattern NNN.NNN.NNN.NNN. This field is required only if its
relative checkbox (IPv4 Destination 1, 2, 3 or 4) is checked.
Test Sends a test trap to the corresponding email address. The Test button will be
enabled when IPv4/ IPv6 Destination Address and IPv4/ IPv6 Network are
CAR-5040 Series User's Manual
All manuals and user guides at all-guides.com
Fig. 5.6.1.3 Trap Settings page
Table 5.6.1.2 Description of Trap Settings format
頁 103