Toro 500 EFI Service Manual page 118

8. Install the CVT cooling ducts on the V-bolt hous-
ing and secure with clamps. Tighten securely.
Install an appropriate nylon tie to secure the
exhaust duct.
9. Install the starter cable to the starter motor, secure
with the nut, and tighten securely; then secure the
engine/harness ground wires to the engine with a cap
screw and tighten to 8 ft-lb.
10. Properly position the gear position switch on the
engine (A to A and B to B); then secure the shift
cable bracket to the engine case and tighten the
engine case screws to 8 ft-lb. Connect the gear posi-
tion switch connector.
116
HDX152A
11. On the left side, connect the ECT sensor connec-
tor, speed sensor connector, and spark plug cap.
HDX135A
HDX149A
12. Install the throttle body into the intake manifold boot
and secure with the clamp. Tighten to 30 in.-lb.
700
HDX252A
500
HDX253A
HDX135A
HDX137A