Fenders; Floor - Toro 500 EFI Service Manual

3. Finish removing the cap screws and flange nuts
(from step 2); then remove the hood assembly.
CLEANING AND INSPECTING
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
1. Place the hood into position on the vehicle; then
install the two outside cap screws and flange nuts.
Finger-tighten only at this time.
2. Open the hood; then install the remaining two cap
screws and flange nuts. Tighten all four securely.
3. Connect the four headlight connectors; then secure
the wires with two new nylon ties.
REMOVING
Remove three torx-head screws securing each fender to
the frame. Account for a stiffener bracket on the front

fenders.

PR332A
INSTALLING
Place the appropriate fender into position and secure with
existing hardware.
REMOVING
1. Remove the seat, seat back, and seat base.
2. Remove the self-tapping screws securing the side
foot restraints.
3. Remove the center floorboard.
PR332
4. While pulling forward on the upper-rear of the floor,
lift the rear part of the floor above the seat locating
stud.
PR332B
Fenders

Floor

PR311A
HDX132A
29