Taillight Assembly; Seat - Toro 500 EFI Service Manual

Taillight Assembly

REMOVING
1. Remove the cap screws and lock nuts securing the
taillight assembly to the ROPS tube.
2. Disconnect the wire connector; then remove the
socket assembly and remove the bulb.
INSPECTING
1. Inspect wiring harness, three-prong connector, lens,
base, cap screws, and socket for damage.
2. Inspect all wires for corroding, pinching, and crack-
ing.
3. Inspect the bulb for wattage, voltage, and proper
operation.
32
INSTALLING
1. Install the new bulb in the socket and place the
socket assembly into the taillight housing. Twist
clockwise to lock.
2. Connect the wire connector; then install on the
ROPS tube and secure with two cap screws and lock
nuts. Tighten securely.

Seat

REMOVING/INSTALLING
1. To remove the seat, raise the front of the seat and
slide it forward.
2. To install the seat, slide the rear of the seat into the seat
retainers and push down firmly on the front of seat.

NOTE: To remove the seat base and seat back, first
remove the four screws securing the seat back and
set the seat back aside. Remove the screws securing
the seat base and set the seat base aside.