Toro 500 EFI Service Manual page 20


NOTE: The arrows on the V-belt should point in
direction of engine rotation (forward).
2. Pinch the V-belt together near its center and slide the
spacer and movable drive face onto the front shaft.
Secure the drive face with a new nut. Using an
appropriate spanner wrench, tighten the nut to 147 ft-
lb (500) or 165 ft-lb (700).
CAUTION
Make sure the movable drive face plate is fully engaged onto
the splines of the clutch shaft before tightening the nut or
false torque readings may occur. This will cause the assem-
bly to loosen damaging the shaft and clutch face plate.
18
GZ085

NOTE: At this point, the CVT cover cap screw can
be removed.
3. With the vehicle in neutral, rotate the V-belt and
clutches counterclockwise until the V-belt is flush
with the top of the driven pulley.
4. Place the CVT cover gasket into position; then install
the cover and secure with the cap screws making
sure the different-lengthed cap screws are in their
proper location. Tighten the cap screws to 8 ft-lb.
CF366
5. Install the gas tank and floor; then install the seat
back, seat base, and seat.
CF379
CF363