Toro 500 EFI Service Manual page 64

14. Remove the oil pump drive gear cap screw.
15. Remove oil pump drive gear. Account for the pin.
16. Remove the snap ring holding the oil pump driven
gear.
62

NOTE: Always use a new snap ring when installing
the oil pump driven gear.
17. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
FI630

To service clutch components, see Servicing Right-Side
Components sub-section.
G. Oil Pump/Oil Strainer

NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
MD1018 18. Remove three cap screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
MD1017
19. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.
MD1019
AT THIS POINT
MD1020
MD1060
MD1337