Installing Left-Side Components - Toro 500 EFI Service Manual

Installing Left-Side
Components

NOTE: Plug the oil passage in the crankcase hous-
ing prior to installing the drive gear/driven gear
assembly to prevent loss of an alignment pin.
1. Install the water pump driven gear alignment pin and
the driven gear (with the beveled side of the gear fac-
ing outward as noted in removing); then secure with
the snap ring.
FI595A

NOTE: The sharp side of the snap ring should be
facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
CD950A

NOTE: The sharp side of the snap ring should be
facing outward.

NOTE: Once the gears are secured, remove the oil
passage plug from the crankcase.
3. Install the two starter gear shafts; then install the two
CD952A
starter gears (with the beveled side of the intermedi-
ate gear facing inward as noted in removing).
CD949
CD946A
CD944
95