Toro 500 EFI Service Manual page 94

7. Using an appropriate side case puller, remove the
side cover. Account for a gasket and two alignment
pins.
8. Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller
adapter.

NOTE: The puller has left-hand threads.
9. Using Magneto Rotor Remover Set and the appropri-
ate crankshaft protector, remove the rotor/flywheel
assembly from the crankshaft. Account for the key;
then remove the starter clutch gear assembly and
washer.
10. Remove the two starter gears from the crankcase not-
ing the direction of the beveled side of the gears for
installing purposes; then remove the two starter gear
shafts.
92
PR441
11. Remove the snap ring securing the water pump drive
gear; then remove the gear noting the direction of the
sides of the gear for installing purposes. Account for the
drive gear alignment pin.
CD939A
12. Remove the snap ring securing the water pump driven
gear; then remove the gear noting the direction of the
sides of the gear for installing purposes. Account for the
driven gear alignment pin.
CD940A
CD136
CD140
CD944
CD952A